[ Pobierz całość w formacie PDF ]
above the bottom of the part and a half-inch to the right. This will only
create half of the arc needed, so the process will have to be repeated to
sketch the other half of the arc.
5. Finish sketching the rest of the part. When you reach the inside .25 radius,
just repeat Step 4.
6. When the sketch is done constrain it to double check that all the
dimensions match the part shown above. Make the necessary changes if
needed.
5.) This will give you more practice using the line and corner icons. Save this
CATPart as Lesson 1 Exercise 5.CATPart .
Part is .50 thk.
CATIA V5 Basic Workbook 1.36
Sketcher Work Bench Creating A Simple Part
Hint: Use the Line or Profile icon first to sketch the profile using sharp corners
(no radius). Once it is constrained to the dimensions above, go back and
add in the radiuses using the Corner icon.
CATIA V5 Basic Workbook 1.37
[ Pobierz całość w formacie PDF ]